Technical data sheet of the Nowa 360 round sensor (NOWDSF360)
Specifications
The round sensors must be:
- Installed at a maximum distance of 50 feet from the control panel. If you need to install them further away, a repeater will be needed for each additional 50 feet.
- On a flat surface for the water to touch, the gold pins that are elevated at 0.4 mm from the ground
- installed where the water will converge. You can use a marble to determine floor slope and predictable water movement over the surface.
- Protected with the provided cage to protect them from pets, children or any action that could move the sensor from its intended location
Physical Dimensions
Width: 2.5”
Height: .37”
Power Specifications
Battery output: 3V 620mAH
Battery type: CR2450
How to dry the device?
Once the round detector detects water, you must dry it before you can reset the alarm. Usually you can wipe it off with a cloth. There must no longer be any water on the sensor and also where the sensor is positioned.
Typically, the sensor is submersible to some degree. On the other hand, if water accumulates inside the sensor, the battery and/or the printed circuit may be damaged and render the sensor inoperative following its detection of water. It is recommended to open the round detector using a small, flat, round screwdriver (the same procedure as for replacing the battery). Once the detector is opened, it is recommended to dry the sensor with cloths. You can also use a dryer to remove any traces of moisture on the circuit board. It is important to use the dryer in moderation so as not to damage the circuit board due to the heat.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article